Use your Bonny Doon press or your rolling mill to emboss finely detailed patterns into your metal using this pattern plate. Created from a special scale-free steel that is softer than the rollers on a rolling mill, this plate will produce a detailed, low-relief pattern on metal up to 16-ga. thick or as fine as 26-ga. (note that these are guidelines for what is possible with these plates; let your experience be your best guide). Instructions are included.
Important: Plates may be used in either your hydraulic press or your rolling mill. Once a plate is used in your rolling mill, however, it will begin to take on a curvature and should not be used in the hydraulic press. The same plate should never be used interchangeably between the mill and press. If you are using the plate in your rolling mill, we recommend annealing your metal before sending it through the rolling mill to achieve cleaner, crisper detail.
Keeping this plate clean and using it only as directed in your rolling mill is critical to prevent damage to your rollers.