How To Use Midas Bright Acid Copper Plating Solution

How To Use Midas Bright Acid Copper Plating Solution

Midas Bright Acid Copper Plating Solution can be used to fill minor casting porosity or as an undercoat when you need a thicker deposition. This solution will not adhere directly over steel, stainless steel, or alloys of tin and lead. Brighteners are included in this solution; the brightness can be maintained using  a replenisher. The copper deposit can also be polished. This solution is provided full strength and ready to use. Use it at room temperature.

All metal parts must be properly cleaned and activated before copper plating. Metals require a strike before plating. Please see the Midas Plating Guide for strike instructions.

Pour the desired amount into a Pyrex beaker. Attach the positive (+) lead to a pure copper anode and immerse in solution. Turn on the rectifier and operate between 1 and 2 volts.

Using a copper handling wire, attach the properly prepared workpiece to the negative (-) lead and immerse it in the solution, agitating gently. Adjust the rectifier if necessary to produce a bright deposit. When finished, rinse in distilled water.

 

Safety Precautions

CAUTION:
CONTAINS ACID! May cause eye, skin and respiratory tract irritation. Avoid contact with eyes, skin and clothing. Use proper safety equipment when handling. Wash thoroughly after use. Keep in tightly closed container. Keep out of reach of children. Please read MSDS.

FIRST AID:
EYE CONTANCT: Flush eyes with large amounts of water for 15 minutes, holding eyelids open. Seek medical attention.
SKIN CONTACT: Wash area thoroughly with soap and water. Seek medical attention if irritation persists.
INHALATION: Remove victim to fresh air. Restore breathing if necessary. Seek medical attention.
INGESTION: DO NOT INDUCE VOMITING! Have victim drink 8-10 ounces of water to dilute the material in the stomach. Seek medical attention immediately.